Mineral processing agent pipeline configuration design

Dressing agent piping configuration design A pipe configuration mode U overhead self-flowing pipe from the drug delivery room is laid along a certain slope, along the wall and column. When passing through the main channel, the pipe erection height should not be less than 2 meters. The main feature of this method is that the conveying distance is short, the reaction rate of the drug changes quickly, and it is easy to maintain and overhaul, saving materials. The disadvantage is that when there are too many systems in the factory, it hinders the appearance of the factory and is not conducive to the maintenance of the flotation equipment . b Gravity press-in type This form is based on the difference in elevation between the drug delivery chamber and the administration point. According to the U-tube principle, the drug is pressed into the drug delivery tube and sent to each administration point. The main feature is that the factory is neat and beautiful, there is no space to cross the pipeline, but it is not suitable for the agent that is easy to produce sediment. The lowest point of the pipeline should be added with a drug discharge gate, which consumes more materials. Both methods have their own characteristics and should be considered in the design. The material of the B pipe is selected according to the nature of the agent and the requirements of the operation. Copper sulfate, sulfuric acid, caustic soda and other acid, alkali agents, should be used in high-grade plastics (Polyethylene) tubing. The general medicine can be transported by hard plastic or steel pipe. For the chemicals required for heat preservation in production, steel pipes should be selected and an insulation layer should be added. The slope of the C pipe is generally determined to be about 3%. When conditions permit, the slope should be increased as much as possible. In order to facilitate management and maintenance, most concentrators use pipeline segmentation or listing methods to distinguish the different types of pipelines. In order to facilitate the inspection of various pipelines, each pipeline should be numbered according to the point of administration, and the relevant instructions should be prepared. The types, consumption, dosing point and mode of administration of the whole plant should be explained.

Flat Paper Rope Making Machine

the flat Paper Rope machines are widely used to make the fat paper ropes for Flat Paper Handle and flat paper bags.