1. When the liquid turbine flowmeter detects the filter capacitor in the power supply, the positive and negative electrodes of the electrolytic capacitor should be short-circuited first, and the lead can be used instead of the lead to discharge the capacitor when it is short-circuited, because it is easy to blow the core wire. It is possible to take a 220V, 60 to 100W lamp with a cap lead, which is connected to both ends of the capacitor. The lamp will flash at the moment of discharge.
Aluminum Die Casting Auto Parts/Car Parts is a metal forming process in which molten aluminum metal is put under pressure and injected into a die. Aluminum Die Casting Auto Parts/Car Parts are lightweight alloys that have good corrosion resistance, mechanical properties, high thermal and electrical conductivity and strength at high temperatures. Aluminum alloys possess high dimensional stability for complex shapes and thin walls.
Aluminum Die Casting Auto Parts/Car Parts is efficient and economical and offers a wide range of durable shapes and components. Little or no machining is required after a part is die cast, because the process provides very close tolerances for even complex shapes. Aluminum die castings can also be easily plated or finished. Aluminum die castings are dimensionally stable and heat resistant
Aluminum Casting Auto Parts, Aluminum Die Casting Parts, Aluminium Auto Parts Ningbo Zhenhai Xinxie Machinery Co.LTD , https://www.xinxie-diecasting.com
2. When using the multimeter's ohmic block, remember that it cannot be charged. When using logic pens and oscilloscopes to detect signals, be careful not to make probes contact both measurement pins at the same time. The essence of this situation is to form a short circuit when the power is applied. When troubleshooting a meter in a wet environment, it is necessary to measure whether the various points on the printed circuit are unobstructed. The main fault in this case is the corrosion of the copper foil.
3. When the internal flowmeter of the turbine flowmeter of the liquid sample is repaired, if the contacts and the circuit board of the mounting component are coated with insulating varnish, the parameters of each point can be measured by using ordinary hand-stitched needles on the test leads of the multimeter so as to pierce the paint layer. Measure the points directly without stripping the paint layer in large areas. It is not possible to hot plug various control boards and plugs. Because of the power-on condition, plugging the control board will generate a strong induced electromotive force. At this moment, the instantaneous counter-attack voltage is very high, and it is easy to damage the corresponding control board and plug.
4, when the maintenance can not be blindly chaotic knock, so as not to expand the failure, the more repair and more bad. When disassembling and adjusting the instrument, record the original position for recovery. When the liquid turbine flowmeter repairs precision instruments and meters, if you accidentally fly a small part, you should first determine where it may fly, and do not look east or west. You can use magnet scanning and line-of-sight scanning methods to find out.
Liquid Turbine Flowmeter Check Route Reasonable Method Introduction