Has the newly purchased tanker been used for a period of time after the oil sucks? The reason needs us to investigate one by one. First, check whether there is oil in the oil pump. The oil pump uses the principle of siphon. If there is no oil, it cannot suck oil. When there is no oil or lack of oil, it needs to be added to the amount of oil that can be sucked. It is generally added to about 10L to ensure that the oil absorption depth does not exceed 5 meters and whether each vent valve is open. Second, check the vacuum indicates the value, if the vacuum is higher, there may be a partial blockage of the suction pipe, the need to see if there is foreign matter in the suction pipe, the suction filter has absorbed too much impurities lead to blockage, can be washed under water; If the vacuum value is low or there is no value at all, there may be looseness at the interface between the suction pipe, the tank, and the oil gun, and the gap is not tightly sealed, or the suction pipe may be damaged. Simply seal the interface of the suction pipe, make up the damaged position of the suction pipe, or replace the suction pipe. 2. The clearance of the oil pump impeller increases. At this time, it is necessary to check and repair the oil pump. Third, abnormal speed increase box, may be due to less lubricant or impurities in the speed increase box, just add or replace the lubricant can be solved. Another possibility is that the parts in the speed increaser box have worn out. It is necessary to remove the parts for inspection. After cleaning, pick out the worn parts and replace them. Fourth, the power take-off box is abnormal, may be 1, the tanker's air pressure is insufficient, the power take-off box is not connected to the file, the pneumatic take-off box pressure is sufficient, so that the barometer value can be above 0.3Mpa; 2, gas path Sealing is not good, power take-off box is not connected to the file, check the gas line to make the tightness tight; 3, the air chamber has a failure, the power take-off box is not connected to the file, check the repair air chamber can be excluded; 4, take the power box Lubricating oil is too little or have impurities, add or replace the lubricant; 5, take the power box parts wear, remove the parts inspection, cleaning and pick out the worn parts to replace.
Color Wrap Film for car body wrapping have gloss,matte, metallic,chrome, chameleon,diamond,holographic,brushed finish and all car color wraps with imported Ishland glue and diamond air channels with good stretchable,very good to install and last long time outside over 3-5 years.
1.Water Resistant and UV Protected.
1. Clean off any dust, dirt or wax or other things before installation.
2. Measure the amount of protective film needed for the part to be fixed.
3. There is a transparent protective film on the surface which must be peeled off before use.
4. With a hair dryer, let the film be flexible and reduce wrinkles.
5. Even though it is waterproof, it cannot be completely submerged in water.
6. After assembly, please leave the car under the sun within 48 hours or do not wash the car in the meantime. Do not let the car stickers touch the water after installation for 48 hours.
Matte Car Wrap,Car Wrap Film,Car Wrapping Film,Gloss Car Wrapping,Car Wrapping Vinyl Guangzhou Fuyulai Technology Co.,Ltd , https://www.fylcarstickers.com
2.Invisible Air-Release Channel, easily get rid of bubbles during installation.
3.Strong self adhesive, eliminate bubbles, peel and stick application.
4.Gloss and smooth finish.
5.Stretchable with heat.
6.Easy to clean with soap and water.
7.Long lasting for approximately 5 years indoor use and 3 years outdoor use.
8.It can also be applied onto most smooth painted or metalized surface such as cell phone, laptop, home appliances, table and even cabinet and much more.
Installation Tips
What can I do if the tanker doesn't suck up?