What is saddle fusion? Saddle fusion (sidewall fuson) is, like butt fusion and socket fusion, another process based on hot plate welding. Saddle heat fusion differs from either socket, or butt fusion methods by performing fusion into the side of the pipe wall in a transverse orientation to the main pipe, rather than in line with the pipe. Hdpe saddle welding required workshop saddle fusion machines. This hdpe fusing process can be conducted while pressurized creating a [hot tap" when allowed by regulations and the pipeline owner. The pipe and saddle fitting surfaces are heated/fusing until they reach a proper temperature, the heating tool is removed and then the weld is formed. The process is complete following a cooling process. Always have a trained joining operator perform this procedure using properly maintained Pipe Fabrication Workshop Machines. For polyethylene reducing tee fabrication, you can view Wuxi Yuda MRH series HDPE/Poly/Polyethylene plastic pipe saddle welding machines on "www(dot)cnbuttfusion(dot)com" Saddle Fusion,Electrofusion Saddle,Saddle Welding Machine,Saddle Fusion Machines WUXI MEIERTE MACHINERY TECHNOLOGY CO.,LTD , https://www.pipefusionwelding.com
It is understood that the bridge is used to measure a variety of tools, such as: resistance, inductance, capacitance and so on. The bridge is a circuit composed of four branches, so each branch is called the “arm†of the bridge. So what little knowledge about the bridge, the following simple to say.
How to use a single-arm bridge:
1, first open the galvanometer lock (inside and outside), adjust the zero adjuster to zero.
2. Connect the measured resistance to the "" position.
Requires thicker, shorter connecting wires and scrapes the paint film. Tighten the connectors to avoid using clips. Poor connection of the connector will make the balance of the bridge unstable and may damage the galvanometer in severe cases.
3. Estimate the size of the resistance to be measured and select the appropriate bridge arm ratio so that the fourth gear of the comparison arm can be fully utilized. This makes it easy to balance the bridge and guarantees 4 significant digits of the measurement result.
4, first press the power button B, (lock) and then press the galvanometer button G (point).
5. Adjust the comparison arm resistance so that the galvanometer points to zero and the bridge is balanced. If the pointer indicates "+", the resistance of the comparison arm needs to be increased and the needle is pointed at "-", then the resistance of the comparison arm needs to be reduced.
6. Read data: Compare arm ratio arm = measured resistance 7. After the measurement is completed, disconnect the galvanometer button, disconnect the power button, and then remove the measured resistance, then lock the galvanometer lock. Damage to the galvanometer during handling.
The value of R2, R3, and R4 is adjusted by the bridge. When the bridge is balanced, R1 = R2 (R3/R4) and the measured resistance can be measured. From the figure we can see: R1 measured resistance includes the lead resistance and contact surface contact resistance, so the actual resistance should subtract lead resistance and contact surface contact resistance, the smaller the measured resistance, the greater the error of the lead, so the single arm The bridge is commonly used to measure the resistance of more than 1 euro, the general range is 1 ~ 99990 ohms. For the switch contact resistance is generally in the micro-European class, should not use this bridge, because the lead resistance is milliohm level, can not be measured, this time you can use dual-arm bridge.
Instrumentation bridge knowledge